Mbx-250 - pure_hw_shutdown signal not working

Tips & Trick By Indiarefix Team If need on Whatsapp Than Ping Your Name City State & Country name to +919310896575
Post Reply
suryajaved
IndiaReFix team
IndiaReFix team
Posts: 569
Joined: Mon Nov 30, 2015 8:37 am
Location: CHANDRAPUR

Mbx-250 - pure_hw_shutdown signal not working

Post by suryajaved »

Sony model : VPC-EG A1829659A,
PCB no.Mbx-250 , 48.4MP01.011
PROBLEM : no power on
Observation : - Ec working condition fail due to missing EC_reset,
Solutions :- In this motherboard ec_reset have a protection of pure_hw_shutdown circuit , "if pure_hw_shutdown signal not working then Ec_reset will not genrate"
One of the Pure_hw_shutdown working condition is depending upon G680_Rst signal, it is generated by u1901(G860) ic , this ic compare high(HTH) and low (LTH) threshold Voltage , (HTH<LTH) if this requirement with vcc and ground are full fill then it,s provide Reset Output in the ckt G680_rst# is output of G680 ic,
So in this board both requirments of G680 is missing because of R1929 show open impedance, it should be 820k according to ckt, after replace R1929 ,G680 requirments full fill and it's so called Output G680 also present so pure_hw_shutdown also present and EC_Rst#, also available on io-controler,
Now board is working .
Attachments
1.jpeg
1.jpeg (47.22 KiB) Viewed 2379 times
5.jpeg
5.jpeg (82.73 KiB) Viewed 2381 times
4.jpeg
4.jpeg (50.33 KiB) Viewed 2381 times
3.jpeg
3.jpeg (106.32 KiB) Viewed 2381 times
2.jpeg
2.jpeg (78.88 KiB) Viewed 2381 times
User avatar
sohailsystem
Newbie
Newbie
Posts: 0
Joined: Mon May 23, 2016 12:28 pm

Re: Mbx-250 - pure_hw_shutdown signal not working

Post by sohailsystem »

Sir I need this schematic
User avatar
sohailsystem
Newbie
Newbie
Posts: 0
Joined: Mon May 23, 2016 12:28 pm

Re: Mbx-250 - pure_hw_shutdown signal not working

Post by sohailsystem »

Sir I need this schematic
Post Reply

Return to “Tips By Indiarefix Team”

Who is online

Users browsing this forum: No registered users and 7 guests