After first reset

Became VIP to access this area. Contact admin
Post Reply
User avatar
Titan
IndiaReFix team
IndiaReFix team
Posts: 10
Joined: Tue Dec 01, 2015 12:31 pm

After first reset

Post by Titan »

Before press Power Button

When Ec Provided by power it active the analog and digitalpower Section
Power plans.png
By default it genrate clock on clock pins (32.768 khz). IfSusclk is used then it provided by intel chipset by rtc section activity.
Clock.png
When Clock is on Clock then Ec reset is take place. Thisdelay must be take place after clock generation. That is because use of RCcircuit used on ECRST#.
ECRST#.png
After ECRST# EC outputclock on EC Bios pin no.6 that is usually 12mhz to 30mhz you can check it byremoving bios chip and than check pin6 for clock with DSO. This is the signalwhich make bios active to input and output data and time selection for chipselect signal to read write opration.
When bios is mounted 3.3v must be there on pin8, pin7andpin3 . Pin 8 is for vcc power for bios chip. Pin 7 for hold for pauseoperations when use low buffer area. Pin 3 is for write protection for device.
Bios cq40.png

When clock present on pin6. EC control CS# signal for Datainput and output operations
When CS# is High chip is not select for Data input andoutput when CS# is in low then EC Input and output made. Ec input data forcertain address to read from pin5 andoutput
Will make from pin2 . Data is generally used in 8 bit.
CS#.png
diganta
Newbie
Newbie
Posts: 12
Joined: Mon Dec 14, 2015 6:34 pm
Location: india

Re: After first reset

Post by diganta »

thank for sharing sir. very use full.
User avatar
javed
TOP poster
TOP poster
Posts: 91
Joined: Mon Dec 14, 2015 10:51 am

Re: After first reset

Post by javed »

thanks sir...
esmat-fadak
Guru
Guru
Posts: 182
Joined: Thu Feb 18, 2016 11:32 am
Location: Kabul, Afghanistan

Re: After first reset

Post by esmat-fadak »

very useful tutorial
User avatar
Ermansha
Newbie
Newbie
Posts: 10
Joined: Mon Jun 06, 2016 2:07 pm

Re: After first reset

Post by Ermansha »

VERY HELPFULL THANKS A LOTS
Post Reply

Return to “VIP area”

Who is online

Users browsing this forum: No registered users and 27 guests