Aspire S7-392 bios problem.
Posted: Sat Jul 29, 2017 4:00 pm
Aspire S7-392 - Wistron Storm 2
Boots by itself without pressing power button.
Current consumption goes up and down from 220 mA. to 768 mA.
I have programmed bios chip many times and with different dumps.
The 3th time, it came to live and boots operative system without problem.
Then after several tests, put all in place, and problem starts again. (I think problem starts again when put lower case)
Replaced bios chip, and reprogram with good dump, but any luck.
As a curiosity, when I try to reprogram bios chip trough usb, (fn + esc) the pen-drive led start to blink, and if it encounters the file Storm2X64.fd, it reads the pendrive, but nothing happen even after past 1 hour.
I want to reprogram the flash inside IT8587VG, but I haven't a flex adapter for keyboard connector. (24 pin 0.5 mm.; and seems that no ec-dump is available in internet)
Any help will be appreciated.
Boots by itself without pressing power button.
Current consumption goes up and down from 220 mA. to 768 mA.
I have programmed bios chip many times and with different dumps.
The 3th time, it came to live and boots operative system without problem.
Then after several tests, put all in place, and problem starts again. (I think problem starts again when put lower case)
Replaced bios chip, and reprogram with good dump, but any luck.
As a curiosity, when I try to reprogram bios chip trough usb, (fn + esc) the pen-drive led start to blink, and if it encounters the file Storm2X64.fd, it reads the pendrive, but nothing happen even after past 1 hour.
I want to reprogram the flash inside IT8587VG, but I haven't a flex adapter for keyboard connector. (24 pin 0.5 mm.; and seems that no ec-dump is available in internet)
Any help will be appreciated.